Dynamic Tilt and Pressure Redistribution

Canadian Clinical Blog by Sheilagh Sherman, BA, BHScOT, MHM, OT Reg. (Ont.) - Sunrise Medical

Hello all,

This month, let’s focus on dynamic tilt, or tilt-in-space, wheelchairs. We will look at the clinical indicators for their use as well as what the research has found regarding dynamic tilt and pressure redistribution.

Dynamic tilt refers to a change in the orientation of the seat pan relative to the ground, while the seat to back angle remains constant. In a dynamic tilt system, the seat pan can be positioned into various degrees of tilt, depending upon the range offered by the tilt system. This is in contrast to a fixed tilt in a wheelchair, in which the front seat to floor height is greater than the rear seat to floor height, while the seat to back angle remains set at 90º or greater, creating a “dump” or tilt to the seating system, which remains at a constant angle. Dynamic recline, on the other hand, refers to a change in the seat to back angle, while the seat pan remains at a constant orientation relative to the ground.

There are many reasons why dynamic tilt may be prescribed for a client. In their position paper on the application of tilt, recline and elevating legrests, the Rehabilitation and Engineering Society of North America (RESNA) (2009) stated that the use of tilt and recline can have many benefits. These benefits include: postural realignment and function; improved physiological functions, such as orthostatic hypotension, visual orientation, speech, alertness, arousal, respiration, eating, and bowel and bladder management; improved transfers and biomechanics; spasticity; changes in pain, fatigue and sitting tolerance; and pressure relief.

It is important to note that although there are several clinical benefits of the use of dynamic tilt, funding sources, if available, may focus primarily on the benefits related to pressure relief. For example, in Ontario, the Mobility Devices Policy and Administration Manual of the Assistive Devices Program (2012), Section 405.01, specifies that a request for funding of a manual dynamic tilt wheelchair will only be considered when such a device is the minimum “required to achieve one more of the following goals:

  1. Increase sitting tolerance where there is risk of tissue trauma due to unrelieved pressure and inability to weight shift independently and/or there is an inability to maintain a functional postural position where abnormal tone is a factor. In both of these situations it must be demonstrated that fixed seating alone is not an adequate solution.
  2. Maintain skin integrity where there is past/present history of tissue trauma, inability to weight shift independently and fixed seating alone is not an adequate solution.

The goals will only be achieved where there is an attendant available to regularly alter the angle of tilt in space.”

(Section 525 of the Mobility Devices Policy and Administration Manual lists the eligibility criteria for power dynamic positioning devices, which are slightly different than the criteria for manual dynamic tilt.)

Many different models of dynamic tilt wheelchairs are available, with differing degrees of maximum tilt available. Have you ever wondered what happens in terms of pressure distribution in various degrees of tilt? Or how much tilt is required to off-load the ischial tuberosities (ITs) and sacrum? Several studies have been published that address these questions.

A recent Canadian study, published in Spinal Cord, took a sample of 18 subjects recruited through an out-patient spinal cord injury (SCI) clinic and measured the effects on interface pressure through pressure mapping as the participants were put into various degrees of tilt (Giesbrecht, Ethans, and Staley, 2011). The study subjects used the same model of tilt-in-space wheelchair and seat cushion. The seat-to-back angle of the wheelchair fixed to 100° for all participants, to be consistent with procedures of previous related studies. The participants each acted as his/her own control, with a starting measurement position of 0° of tilt. The researchers then took pressure mapping measurements of the ITs and sacrum of the participants in various degrees of tilt (10°, 20°, 30°, 40° and 50°).

What the researchers found was that at least 30° of tilt was required to effect a reduction in pressure of clinical value, which was consistent with previous published research. In 10° of tilt, there appeared to be less than 5% reduction of interface pressure, but with increased loading on the sacrum. In 20° of tilt, there was less than 15% reduction in pressure. Giesbrecht et al. (2011) concluded “Small tilt angles are more suitable for postural control than pressure management.” (p. 827.)

The researchers further found that “A minimum tilt of 30° is required to initiate unloading the sacrum and to achieve a clinically important reduction in pressure at the IT. Larger tilt angles resulted in more substantial pressure reduction than previously reported.” (Giesbrecht et. al., 2011, p. 827). In this study, increasing the angle of tilt from 20° to 30° resulted in a reduction in interface pressure of ~ 15%; increasing from 30° to 40° resulted in another ~20% reduction; and increasing from 40° to 50° resulted in a further ~ 25% reduction in pressure at the ITs and sacrum.

Another research study looked not only at interface pressure measurements, but also blood flow through Doppler measurement when eleven study participants with SCI were positioned in various degrees of tilt (Sonenblum & Sprigle, 2011). In this study, participants used their own wheelchairs and seating and were measured in various randomized tilt sequences, including upright to 30º, upright to 45º, upright to maximum tilt (whatever maximum tilt was possible on the participant’s own wheelchair – 45° or 55°), and upright to 15º to 30º. Upright referred to the minimum degrees possible on the participant’s wheelchair, that varied between 0° and 5°.

Sonenblum et al. (2011) found “a tilt of only 15° has a small (8%) but significant increase in superficial blood flow. Pressure did not significantly decrease at 15° of tilt; in some subjects, the pressure actually increased slightly.” Tilting from 15° to 30° resulted in decreased pressure, but did not result in further increased blood flow. The authors hypothesized that there are other mechanisms affecting blood flow besides changes in tissue loading. In tilts up to 45°, it was found that there was a large variation in blood flow response of the participants, while interface pressure measurements decreased with greater degrees of tilt. Sonenblum et al. (2011) concluded “Based on the results of this study, tilting for pressure reliefs as far as the system permits is suggested to maximize the potential for significant blood flow increases and pressure relief. The use of interim small tilts is also supported, as they also provide some benefit.” (p. 3.)

Many times therapists are surprised at what is required to achieve 30° of tilt for pressure management. If you are unsure of how much tilt is needed to obtain 30° of tilt, the next time you have the opportunity to use a tilt wheelchair that has a built-in inclinometer, I encourage you to tilt the chair and check the inclinometer to see how far back the chair must be tilted in order to achieve 30° of tilt. If you have access to a dynamic tilt wheelchair that does not have an instrument to measure the angle of tilt, you can use a goniometer to measure the degree of tilt of the wheelchair.

In summary, we found that the use of dynamic tilt wheelchairs can have numerous clinical benefits for clients. Often, dynamic tilt wheelchairs are prescribed as a means for pressure redistribution when a client is at risk of skin breakdown due to an inability to weight shift independently. The research demonstrates that small degrees of tilt appear to be beneficial for blood flow and for positioning. Tilt of at least 30° showed some unloading of pressure at the sacrum and a clinically important pressure reduction at the ITs, while greater degrees of tilt demonstrated even greater pressure redistribution away from the pelvis.


  1. Assistive Devices Program. Ministry of Health and Long-Term Care. (2012). Mobility Devices Policy and Administration Manual. Retrieved from: http://www.health.gov.on.ca/en/pro/programs/adp/update_vendor_agreements/docs/mobility_devices_manual.pdf
  2. Dicianno, B.E., Arva,J.,Lieberman, J.M.,Schmeler, M.R.,Souza, A.,Phillips,K., Lange, M., Cooper, R., Davis, K. & Betz, K.L. (2009). RESNA Position on the Application of Tilt, Recline, and Elevating Legrests for Wheelchairs. Assistive Technology,21(1), 13-22.
  3. Giesbrecht, E.M., Ethans, K.D., and Staley, D. (2011). Measuring the effect of incremental angles of wheelchair tilt on interface pressure among individuals with spinal cord injury. Spinal Cord, 49, 827-831.
  4. Sonenblum, S.E. & Sprigle, S.H. (2011). The impact of tilting on blood flow and localized tissue loading. Journal of Tissue Viability, 20, 3-13.

As always, please provide your comments, questions, and suggestions regarding Clinical Corner. Please email me at Sheilagh.Sherman@sunmed.com. I look forward to hearing from you!

Sheilagh Sherman BA, BHScOT, MHM, OT Reg. (Ont.) - Clinical Education Manager, Canada

Sheilagh Sherman, BA, BHScOT, MHM, OT Reg. (Ont.)

Sheilagh Sherman joined Sunrise Medical Canada in 2010 as a Clinical Educator. Prior to joining Sunrise, Sheilagh gained extensive clinical experience working in a variety of settings, including neurological rehabilitation, complex continuing care, and community rehabilitation. As the Clinical Education Manager, Sheilagh is a clinical resource for therapists across Canada involved in seating and mobility. She leads workshops, seminars, and webinars on the clinical aspects of seating and mobility. In addition, Sheilagh has presented at national and international conferences on seating and mobility.

Sheilagh also has an educational background that makes her well suited to the role of Clinical Education Manager. Sheilagh earned a Bachelor of Arts degree in Political Science from the University of Toronto in 1988, which enables her to understand healthcare policy and policy changes. Sheilagh graduated with a Bachelor of Health Sciences (Occupational Therapy) degree from McMaster University in 1994. In 2012, Sheilagh earned a Certificate in Adult Education/Staff Training from Seneca College. She applies adult learning principles to the workshops she leads. Finally, she also has a Master of Health Management (MHM) degree from McMaster University after graduating in 2015. Courses that Sheilagh completed during the MHM degree, such as Knowledge Translation, Evaluating Sources of Evidence, and Quality & Safety in Healthcare, assist Sheilagh in using an evidence-based approach in her work.

In her free time, Sheilagh enjoys running, in addition to practicing yoga.

Date: 2012-10-18

DISCLAIMER: FOR PROFESSIONAL USE ONLY. THIS WEBSITE (AND THE DOCUMENTS REFERENCED HEREIN) DO NOT PROVIDE MEDICAL ADVICE. Sunrise Medical (CA) LLC (“Sunrise”) does not provide clinician services. The information contained on this website (and the documents referenced herein), including, but not limited to, the text, graphics, images, and descriptions, are for informational purposes only and should be utilized as a general resource for clinicians and suppliers to then use clinical reasoning skills to determine optimal seating and mobility solutions for individual patients. No material on this website (or any document referenced herein) is intended to be used as (or a substitute for) professional medical advice, diagnosis or treatment. Never disregard your professional medical training when providing medical advice or treatment because of something you have read on this website (or any document referenced herein). Clinicians should review this (and any other materials) carefully and confirm information contained herein with other sources. Reliance on this website (and the information contained herein) is solely at your own risk.


AdaptedStrollers AdaptiveDriveControls AdjustableSeating Anniversary assessment BackRest BackSupport Bariatric Batteries BestPractice BodyShape Camber CasterHousingPosition CentreOfGravity ChangeInFunction ClinicalEducator COG Comfort ControlModule Cushion CushionCover CushionDesign CushionMaterial Customization CustomSeating Design dissipation DriveWheel DynamicTilt EarlyInterventionDevices Edema Education ElectricScooters ElectricWheelchair Electronics Encoders Falls FallsPrevention FemoralLoading Growth Handcycling Hardware HeadRest HeadSupport Heat ISO7176-19 KnowledgeTranslation LateralPosition Maneuverability Manual ManualWheelchair ModularFrame ModularSeating Moisture Motors OccupantRestraint OccupationalTherapy OTA/PTA OutcomeMeasures Outcomes Parasport PelvicObliquity PelvicRotation positioning PosteriorPelvicTilt Postural PowerAssist PowerMobility PowerWheelchair Pressure PressureInjury PressureManagement PressureRedistribution PressureUlcer PreventionOfSliding Programming protection PushrimActivatedPowerAssistWheelchair RearWheel Recline RehabAssistant ReviewArticle Rigid rigidity RigidWheelchair RollingResistance scooter Scooters SeatElevation Seating SeatingAndMobility SeatingGoals SeatingProductParameters skin SkinProtection Sliding SpecialtyControls Sports StaffTraining StandardizedTerms StandardWheelchair SteerCorrection supports technology TherapistAssistant Tilt Tilt-in-Space TiltMechanism transit VibrationDampening WC18 WC19 WC20 Wear Weight WeightShift WeightShifting Wheelchair wheelchairbasketball WheelchairConfiguration WheelchairCushion WheelchairProvision WheelchairProvisionSteps WheelchairTennis WheelchairTiedowns